how to get into raid screen when booting?

[Glaucus]

unplugged the wrong hdd (part of a raid 0) booted up. Obviously said no operating system found.
Booted down replugged it, now it just says no operating system found and doesn't recognise the two drives as a raid drive.

How do I get into the raid controller on boot up and is it possible to fix this?
Either way still need ot get into the raid controller to set it up again, f I can;t fix it.

 

[adamscybot]

unplugged the wrong hdd (part of a raid 0) booted up. Obviously said no operating system found.
Booted down replugged it, now it just says no operating system found and doesn't recognise the two drives as a raid drive.

How do I get into the raid controller on boot up and is it possible to fix this?
Either way still need ot get into the raid controller to set it up again, f I can;t fix it.

Read the motherboard manual?

Its changes depending on the mobo. I think mines Ctrl + g.

 

[Glaucus]

No manual asus p5k

 

[Cosimo]

No manual asus p5k

Here you go:

http://www.lamals.cz/ceniky/datasheety/motherboard/asus/p5k_manual.pdf

 

[adamscybot]

Here you go:

http://www.lamals.cz/ceniky/datasheety/motherboard/asus/p5k_manual.pdf

Lol, yeh just about to say. Found manual in less than 2 seconds on google :/

 

[adamscybot]

Its Ctrl-J

 

[Glaucus]

ctrl+J doesn't work, jmicron is enabled in bios.
an ideas.

 

[ChileanLlama]

Is jmicron set to IDE or RAID - CTRL+J won't work unless it's set to RAID.

 

[Glaucus]

Is jmicron set to IDE or RAID - CTRL+J won't work unless it's set to RAID.

tried setting it to both

 

[ChileanLlama]

Have you got any other cards with a BIOS installed? You could try setting Interrupt 19 Capture to disabled in case something else is getting priority over the jmicron bios screen.

 

[Glaucus]

Have you got any other cards with a BIOS installed? You could try setting Interrupt 19 Capture to disabled in case something else is getting priority over the jmicron bios screen.

There is a cd drive screen saying press any key to continue. Its always been there. How would I disable that?
It used to be post screen, followed by 5 seconds of cd drive screen, followed by 5seconds of jmicron screen.
Now it goes post > cd > missing operating system.

I think it might be the cd screen causing the problem. even if I press ctrl-j at post up. It seems to count that press as the press any key for this screen.

 

[Glaucus]

Cheers guys sorted it.

Had jmicron set to raid.
But there's another hidden setting under sata config. That was set to ide. Changed it to raid and hey presto Straight back in.

 

[ChileanLlama]

Does the CD screen mention jmicron - it sounds like it is running in PATA/IDE mode and not RAID? Can you hit CTRL+J at that point?

 

[ChileanLlama]

Cross post Glad u got it sorted