I cant fit my hdd in this case; CM 690 Advanced

Arshad07 · 26 May 2010 at 13:16

Its like the HDD is a bit too big.

Any help please

ricky · 26 May 2010 at 13:49

First,slide the hd caddy out completly.
You have to slot them in at a 45 degree angle.Put one side in,so the pins locate in the hard drive,then push the other side down,you have to bend the hd caddy a little.

Arshad07 · 26 May 2010 at 13:53

Ok i will try that and report back. Thanks

ricky · 26 May 2010 at 14:04

I struggled with mine too,untill the girlfriend walked over,looked at the instructions,picked it up,and fitted it first time...women,always reading the instructions!!

Arshad07 · 26 May 2010 at 14:10

SOrry to spam here but i couldnt stop laughing hahaha

DIABLO · 26 May 2010 at 18:00

As said you slot one side of the harddrive in then bend the caddy out so the pins fill fit passed the drive and drop in the holes.

Gary* · 26 May 2010 at 18:03

ricky said:
I struggled with mine too,untill the girlfriend walked over,looked at the instructions,picked it up,and fitted it first time...women,always reading the instructions!!

You Sir, got pwned.

PhillyDee · 26 May 2010 at 18:06

Its not upside-down is it?

NutterzUK · 28 May 2010 at 19:33

Just take the whole caddy out and look at it. It's the same case as i've got. It's only a case of putting one side in, then pulling the side of the caddy out a bit so you can see what you're doing and putting the other in. I've got 3 hard drives in mine, the SSD mounting was the hardest

.
I'm sure the little rubber bits come out too.