I have a problem need help

[Ilikeitblackplease]

when I boot up via dvi the boot screen is fine, when it load windows it is fine, but once I install the drivers the screen becomes fuzzy only in windows view picture.
but if I connect my hdmi cable the picture is fine, even with the drivers.
so

hdmi with no drivers installed screen is fine, boot up screen fine windows screen fine
hdmi with driver installed screen is fine. boot up screen fine windows screen fine
dvi with no driver installed screen is fine, boot up screen fine windows screen fine
dvi with driver installed screen is fuzzy. boot up screen fine windows screen fuzzy

I have replaced the card with a new one and the same thing happens.

Operating System : Windows 7 64bit
[Motherboard Specification]
Motherboard Vendor : msi
Motherboard Revision : z97-g45 gaming( ms-7821)
Motherboard BIOS Revision : v2.4

[CPU Specification]
CPU Vendor : intel
CPU Type : i5 4690k
CPU Speed : 3.5

[Memory Specification]
Memory Vendor : corsair
Memory Model : cmz8gx3m2a 1600c9
Memory Capacity : 8 gig

ASUS Graphics Cards R9290X-DC2OC-4GD5

ATI Display Driver 13.251WHQL for Win7 32/64, Win8 32/64, Win8.1 32/64
File Size 292.08 MBytesupdate 2014/01/07


update1 ok now if I lower my resolution to 1920 x1080 the monitor seems fine, its when I want the max 2560x1440 it give me that. my 3 monitors are dell 2713 HMt they support 2560x1440 and i guess my graphics card does too. so now wondering if it could be the cable.

 

[Ilikeitblackplease]

also your description is quite confusing. The screenshot looks like BIOS Post logo which you say is fine but the picture shows corruption.

Perhaps re-read what you have put and try again with more detail, like as said drivers, type of card, motherboard, monitor etc etc etc.

have it in dual mode with two monitors is just a desktop picture.

 

[Ilikeitblackplease]

If your monitors are the same have you tried swapping them over, the issue could actually be with the DVI input on that monitor /shrug.

think the label on the cable could be wrong.

 

[Ilikeitblackplease]

In CCC there are a couple of tick boxes to try for higher res DVI.

ccc?

 

[Ilikeitblackplease]

FWIW, you need a DVI-D Dual Link or DisplayPort connection to be able to drive the U2713HM at 2560x1440. I suspect your DVI cable isn't a DVI-D DL one ... check https://en.wikipedia.org/wiki/Digital_Visual_Interface#Connector to tell what cable(s) you have.

i order a new cable, thought these ones were dual ill find out tomorrow. my old card had 2 displayport connection 280x my new card 290x has only one go figure.

 

[Ilikeitblackplease]

it was the cable.