I5-13600k overheating

[maun]

Hi, need some advice. Have a new build Gugabyte Z790 UD AX with a I5-13600K and Dark Rock Pro 5.

Whenever I run Conebench processor hits 100c instantly. I’ve reseated the cooler, thermal compound etc. I know there is this Intel power limits problem but I’ve put the latest BIOS on which has the “correct” options enabled my defaults.

Any thoughts what I can try to lower them at all?

Thanks

 

[maun]

Are you on the latest bios with the new Intel profiles?

Yes I’ve just put the latest on and it states they’re enabled by default with that one.

 

[maun]

Have you had the issue since you have built the system or has this just recently started?

New system built yesterday.

 

[maun]

Looking at the manual for the cooler there is 2 screws holding it in place.

When screwing these up did you do a little on 1 side and then move to the other then back again?

Just making sure that 1 screw was not tightened up fully before moving to the other side so the mounting is level

yeah I’ve fitted these many times, never do up one at a time etc.

 

[maun]

Sitting idle fluctuates between 34-45c with an avg of 37c and that’s after 10 minutes.

Hwinfo saying both PL 1/2 power limit (static) @ 181w.

Under cinebench load CPU package power showing max 175w give or take.

Hope this helps.

 

[maun]

Sorry is this sounds patronising but you remove the protective plastic film at the bottom on the cooler?

Haha no worries, yes I have done!

 

[maun]

Responding to instant high loads can be quite difficult for air coolers, depending on the fan profile.

What is your usual temp in games?

I haven’t tested any games, I know testing utilities like cinebench push it more than games, but consistently hitting 100c just doesn’t seem right still?

 

[maun]

Have you changed any of the fan settings? what speed is the fans running at during the run?

Heat sink just set to Normal, and hits 1600rpm at full load