IN the loop

[Essadqi]

Hi everyone
I intend to build my first water cooling custom loop for which I'll use an Obsidian 900D and I have some questions to ask, I've been searching the web but a lot of my concerns found no clear answers so I hope I'm in the right place, after all, as a Corsair enthusiast this is the place to be.
1. My loop will include two EK-CoolStream PE 480(one up and the other bottom right) one EK-CoolStream PE 360(bottom left) and one EK-CoolStream PE 120(rear exhaust). Is this enough for cooling the southbridge the cpu and two gpus?
2. Knowing that these radiators are 38mm thick and that I'm going for push/pull, is there enough room to add one EK-CoolStream PE 240 in the front of the case juste between the two bottom radiators?
3. Which Corsair 120mm fans you recommend? Should I go for static pressure or airflow optimized fans?
I will be very greatful if some one would help me out. Thanks.

 

[jacob1995knight]

1. You dont need a 120mm radiator in a setup like that, it wont really make any noticeable changes in temperatures, it will however add a restriction to your loop.

2. You need to have air movement in between radiators, fans especially, so there will be no room for that 240mm radiator (i hope you where going to add fans)

3. I recommend going for static pressure fans as these are going to be used on the radiators

After covering all of that, should be a decent setup, whats the hardware that will be in the loop? processor and gpus?