input on new watercooling set up

clayer · 9 Nov 2014 at 17:03

hi, i was going to upgrade whole rig to go with new rog swift after a lot of thought my current cpu/board is more than enough for my needs, so i have decided to add 2x 980 full cover/blue b/plates and upgrade my loop.
external 420 monsta-quick release push pull
bottom 240 -monsta-push pull
top ut45 pull
front 140 monsta push pull option to add 120 at rear of case.
to move this water going with-EK Water Blocks EK-DDC Dual 3.2 PWM X-TOP Including Pumps+tube res
adding full board monoblock to R4BE not many reviews on this ?
im hoping to run this at lowest fan settings to achieve almost silent build with a monsta set up. all blue monsoon fittings/uv red tube.
i could split the loop and dedicate external to gpus ?
any recommendations ideas etc greatly received
thanks

Mynight · 9 Nov 2014 at 17:12

If quiet is your aim have you considered running completely passive? Since you don't appear to mind external rads you could go with an absolute monster external rad.

Jokester · 9 Nov 2014 at 17:15

The monoblock is based on the Supremacy CPU block, so it's about as good as you can get.

clayer · 9 Nov 2014 at 17:18

im a bit fussy about the look of things the external monsta with silent leds is the look im after i already have a 250/250mm shelf above my pc with some crappy ornament on it lol it would sit perfect and look cool plus in the summer months i can turn up fans and cool down lol.

clayer · 9 Nov 2014 at 17:19

ok thanks jokester ill go with 1 of them

Mynight · 9 Nov 2014 at 17:21

clayer said:
im a bit fussy about the look of things the external monsta with silent leds is the look im after i already have a 250/250mm shelf above my pc with some crappy ornament on it lol it would sit perfect and look cool plus in the summer months i can turn up fans and cool down lol.

Sounds like a solid plan actually

.

clayer · 15 Nov 2014 at 21:53

hi,
decided to go with 420 monster and pump res externally dedicated to gpus is there any benefit in parallel or series, there is going to be a fairly long run of tubing but as its only going to gpus should pump round just fine ?
thanks

clayer · 15 Nov 2014 at 21:57

also today i built a skate board for pulling out pc 1 piece of hardwood 5 castors 1 tin of ebony stain. shaped the front to match case will post pics.
cost £32 could have saved a bit tin of stain was way to big.