Hi
I have a dual-boot Dapper/WinXP setup with 3 hard drives
hda - old 40 gig IDE
sda - 250 gig non boot drive
sdb - 200 gig dual boot drive
If i load up Edgy from the live CD and run the install Gparted sees all 3 drives BUT when i click on manually edit partition table (as i want to overwrite my current Dapper installation) it only shows hda and sda.
Any ideas how i can get around this?
Thanks
Diss
I have a dual-boot Dapper/WinXP setup with 3 hard drives
hda - old 40 gig IDE
sda - 250 gig non boot drive
sdb - 200 gig dual boot drive
If i load up Edgy from the live CD and run the install Gparted sees all 3 drives BUT when i click on manually edit partition table (as i want to overwrite my current Dapper installation) it only shows hda and sda.
Any ideas how i can get around this?
Thanks
Diss