Intel Burntest result?

[Dan2kx]

Hello,

So i FINALLY got my C2 chip today and after an initial GPU related nightmare (assumed bios was the latest, wasted about 3 hours trying to resolve driver crashes) i finally started overclocking....

using the multi i got 4.7ghz with 1.38v, but burntest said it was unstable (better than the previous crashes i had had previously)
the gflops where around 130 at that time,

i increased voltage to 1.39, burntest now completes but runs at 77 gflops?

whats goin on?

 

[Sayso]

Sounds like throttling!

 

[Dan2kx]

Temps are fine, hardly above 60 why would it be throttling then?

 

[j.col]

i increased voltage to 1.39, burntest now completes but runs at 77 gflops?

whats goin on?

how are you running the test?
http://forums.overclockers.co.uk/showthread.php?t=18297411

 

[Dan2kx]

i think so? i just did a standard test, the maximum was taking too long

i had to clear cmos at some stage and now i am getting 133ish again at 1.40v (4.7ghz)

is that a good score then?

 

[N00bbuilder79]

4.7 @ 1.4v, I might stick with my C1

 

[Dan2kx]

4.7 @ 1.4v, I might stick with my C1

what you got?

 

[N00bbuilder79]

I can get a stable 5.1 at 1.41v

Is that as high as you can go on the multi at that voltage with it being unstable?

 

[Dan2kx]

i havent tried going any higher, i set the muti at 47 and then took the volts up, i did have some issues (in OP) so after i reset cmos i just continued from where i left off, which was 1.4, i might go back down now, or bang it up to 48 etc,

 

[N00bbuilder79]

Are you running 1101 BIOS?

 

[Dan2kx]

Yeah I am now,
Just tried 48 but it failed

It could just be that I'm doing it wrong? Lol

 

[N00bbuilder79]

Does it post at all with a higher multi?

 

[Dan2kx]

Yeah It blue screened before windows though