Ip Address for Access Point on Virgin Media

[Dinsey]

I have VM broadband and am running a Meraki MR12 Access point.

I need to check that I am running the correct config with my meraki. As the Meraki is not giving me the same perfromance that i get from the Virgin Media router.

I have the Virgin modem / router ruining in dchp mode with a dchp reservation for 192.168.0.18 (this is the meraki acesss point).

Network cable runs from the network port on the virgin router to a switich then to the access point.

I have a static ip assigned in the meraki config:

IP: 192.168.0.18

VLAN: blank

Subnet mask: 255.255.255.0

Gateway 192.168.0.1


Primary DNS 192.168.0.1

Secondary DNS: blank

The ssd's in meraki are:

NAT mode: Use Meraki DHCP
Clients receive IP addresses in an isolated 10.0.0.0/8 network. Clients cannot communicate with each other, but they may communicate with devices on the wired LAN if the SSID firewall settings permit

Is this all okay or should i be running in bridge mode?

 

[Dinsey]

Thanks, just checked it's a MR18, is this better?