Is anyone using these fittings?

inSilica · 9 Mar 2012 at 19:54

I thought I would share these fittings, 30 degree ball rotational fitting. TBH I just got fed-up of counting up joints angles etc... [it's a non-conventional loop (will post pics by Sunday hopefully)] so got these as an in-between straight fittings and angled fittings

Will be plugging these in tomorrow with 7/16" Masterkleer tubing

.

pgi947 · 9 Mar 2012 at 20:29

An interesting design, is there a compression version?

panyan · 9 Mar 2012 at 20:52

i have a feeling that the reason we dont see many ball fittings is that they are prone to leaking - but i may be completely wrong

minicle · 9 Mar 2012 at 20:59

You can make pretty much any rotational fittings leak if you aren't careful, at least I managed to... :rolleyes:

Am looking forward to seeing photos of these tomorrow

Hyburnate · 9 Mar 2012 at 21:17

Yeah, reputable manufacturer they shouldn't leak

cjgardens · 10 Mar 2012 at 16:47

they look great? might be a little restrictive

inSilica · 10 Mar 2012 at 19:26

cjgardens said:
they look great? might be a little restrictive

Yes I can say they are a teeny winsey bit restrictive at full tilt.

Am looking forward to seeing photos of these tomorrow

Will make a start but DPD rang while I was in the loo ....

My graphics cards are at the delivery Depot! Damn inpatient so and so, got out to see the back of the van driving off.

arg!!!!!

Couldn't re-arrange delivery, damn Sat delivery

Hyburnate · 10 Mar 2012 at 22:26

inSilica said:
Yes I can say they are a teeny winsey bit restrictive at full tilt.

Will make a start but DPD rang while I was in the loo ....

My graphics cards are at the delivery Depot! Damn inpatient so and so, got out to see the back of the van driving off.

arg!!!!!

Couldn't re-arrange delivery, damn Sat delivery

I don't do anything if I'm expecting LOL