Is anyone using these fittings?

[inSilica]

I thought I would share these fittings, 30 degree ball rotational fitting. TBH I just got fed-up of counting up joints angles etc... [it's a non-conventional loop (will post pics by Sunday hopefully)] so got these as an in-between straight fittings and angled fittings

Will be plugging these in tomorrow with 7/16" Masterkleer tubing .

 

[inSilica]

they look great? might be a little restrictive

Yes I can say they are a teeny winsey bit restrictive at full tilt.

Am looking forward to seeing photos of these tomorrow

Will make a start but DPD rang while I was in the loo ....

My graphics cards are at the delivery Depot! Damn inpatient so and so, got out to see the back of the van driving off.

arg!!!!!

Couldn't re-arrange delivery, damn Sat delivery