Is this normal

limpep

limpep

limpep

Associate
Joined
24 Jun 2007
Posts
20
Hey got an H50 installed but when the cpu load is on 90+ the temp increase to about 80+ and I dont think this is normal. Here is a test i did

unormal.png


I aslo did a test with prime95 it goes all the way up to 100c. Here are some graphs.

cpu1
2010-05-17-20h17-CPU1.png


cpu2
2010-05-17-20h17-CPU2.png


cpu3
2010-05-17-20h17-CPU3.png


cpu4
2010-05-17-20h17-CPU4.png



I was thinking if I should lower the vcore currently at 1.344 down which would also give better temp at load.
 
Ok well the issue was with the fan it self not the h50, it seemed as the old fan was taking in air instead of out so I changed it with a different one. Here are the new readings.
cpu1



cpu2


cpu3


cpu4


What voltage is recommanded?
 
Ordokai said:
I'm certain you can go lower than that unless you were really unlucky with the chip. Try it at 1.230.

Need I remind you that its not the extra volts that make the CPU faster, its the clocks and the less juice you need to sustain them, the better.


- Ordokai
Click to expand...
Will try. I also currently have the dram bus voltage at 1.64.
 
Well its seems the more i decrease the voltage the more system crashs i get. I am currently at 2.8 which seems to be ok so far.

here is my set up

Corsair 6GB (3x2GB) DDR3 1600
Antec Nine Hundred Two Case
Asus P6T SE X58 MoBo
Intel Corei7 920 D0 Step SLBEJ
CORSAIR 750W 750HXUK MODULAR
CORSAIR H50 CWCH50-1 INTEL/AMD
NZXT SENTRY TOUCH LCD METER
1GB XFX HD5770 DDR5 PCI-E
 
You must log in or register to reply here.
Back
Top Bottom