Issue with z axis on my P1S

[chris blackford]

Hi I have a Bambu lab P1S when I do self test my printer makes strange noise when it get to floor of printer and after sum times of going up and down it stops and when useing the controlls to send bed up by 10 each time when it gets about middle it makes a beep like sound and stop sooner than should and the error code I get when doing self test is 0x3004000

 

[Dano]

Better off googling the error code than asking here: https://forum.bambulab.com/t/homing-z-axis-failed-0300-4000-093824/17433/29

 

[chris blackford]

Better off googling the error code than asking here: https://forum.bambulab.com/t/homing-z-axis-failed-0300-4000-093824/17433/29

All ready did that just means z axis is stuck can't find any thing in way

 

[pigeonguyuk]

Literally had this the other day.

there was a narrow 2-3mm purge block that got stuck betwnn the base and side encolsure literally couldnt feel it only realised when there was a bulge in side panel

 

[chris blackford]

Literally had this the other day.

there was a narrow 2-3mm purge block that got stuck betwnn the base and side encolsure literally couldnt feel it only realised when there was a bulge in side panel

Hi where would you recommend checking if look around but can't see any bits?

 

[chris blackford]

Here sum videos i toke to show what I mean

 

[chris blackford]

Noiced this?

 

[pigeonguyuk]

That would be an issue for sure

Also there more greese there than P Doddys mansion. That will need a sever clean as over greesinf will mean inadequate tension on the belts

 

[chris blackford]

That would be an issue for sure

Also there more greese there than P Doddys mansion. That will need a sever clean as over greesinf will mean inadequate tension on the belts

What is it where would it be from dident want too remove it with out knowing what it is lol