Hi,
Every time I switch my Epson tw3200 projector on I keep getting this message
Source: hdmi1
Not supported h: 67.43khz v: 59.90hz
If I switch the projector off and then switch if on again it works fine. or if I press hdmi 2 then press hdmi 1 on the remote it works fine.
The hdmi cable is 15m long and goes from the back of the projector and plugs into the amp.
Any suggestions?
Every time I switch my Epson tw3200 projector on I keep getting this message
Source: hdmi1
Not supported h: 67.43khz v: 59.90hz
If I switch the projector off and then switch if on again it works fine. or if I press hdmi 2 then press hdmi 1 on the remote it works fine.
The hdmi cable is 15m long and goes from the back of the projector and plugs into the amp.
Any suggestions?