Kraken G12 Install

NeverWinter · 23 Oct 2018 at 21:37

I've recently installed a G12 on to my Zotac 1080 AMP, it has a 92mm PWM fan attached via a GPU FAN PWM adapter, however it's constantly running full blast.

Tried manually setting it in afterburner to no avail, any ideas?

Other than that, temps are great now!

NeverWinter · 24 Oct 2018 at 10:05

In order to slow the fan down I've attached it to my PWM controller for my case fans.

This has slowed it down but this means I can't control it with a fan curve when the GPU heats up.

NeverWinter · 25 Oct 2018 at 08:31

Using the OcUK kit, so an Asetek 240mm 570LX so it's connected to the motherboard headers and no software.

The problem was it wasn't slowing down.

The VRMs and VRAM have heatsinks on them though so I may be alright, but without any temp sensors on them I can't tell and would prefer a fan curve from the GPU when it heats up, rahter than currently relying on the CPU heating up to increase PWM.

NeverWinter · 25 Oct 2018 at 14:52

ShowdownPhil said:
What about using a fan hub (something like this) and joining it up with the radiator fans connected to a motherboard header? That way, when your GPU is under load the 92mm fan will speed up with the GPU rad fans... and spin down with the rad fans when the GPU is idling.

I've already done this, however this only works when the motherboard starts to heat up - not the GPU on its own.

NeverWinter · 26 Oct 2018 at 10:18

I'll have a look in to speedfan, see what I can do.