Lian-Li GC Support Bracket - Am I being dumb?

Mike_J_Smith · 2 Feb 2021 at 15:14

I've just built a new computer using the OD11 XL. I tried to install the graphics card support bracket which uses risers which screw into the motherboard standoffs.

Problem I had is that the risers screw was too large and didnt fit the hole of the stand-off.

Has anyone else fitted one of these? What am I missing?

I'll probably end up getting a vertical mount anyway, but this is annoying me!

Mike_J_Smith · 11 Feb 2021 at 19:48

Turns out I'm not being dumb! The threads on these risers are completely wrong for a motherboard stand-off. I've tried to contact Lian-Li but they've shut down for Chinese New Year.

thepfy · 13 Feb 2021 at 18:14

With my kit, there were two sets of stand offs. One set were too big for the screw holes but the other set were fine.

Works well on my Lancool Ii with an Aorus X570 Elite and 3060Ti Fe, despite the GC brackets being some bits from a Mechano set.

Mike_J_Smith · 13 Feb 2021 at 23:12

thepfy said:
With my kit, there were two sets of stand offs. One set were too big for the screw holes but the other set were fine.

Works well on my Lancool Ii with an Aorus X570 Elite and 3060Ti Fe, despite the GC brackets being some bits from a Mechano set.

Ooh, interesting. I'm going to have a dig around now. I don't remember seeing others, but I guess I'd go back to being dumb if there are

Mike_J_Smith · 18 Feb 2021 at 22:36

COOLB34N5 said:
Think fractal design kit fits your case of the top of my head

Cheers. I'll get a vertical mount at some point. I could probably just but a couple of risers myself if I wanted too as well, just annoying that it comes wrong. I wonder if they just got a dodgy batch themselves.