Lian Li Mobo Question

fail at the internets · 7 Jun 2007 at 21:24

How do i mount my DS3R to the Lian Li 7 without it being on the side of the case, because the only option i can see is to screw it to the right case panel, but wouldn't that short circuit it?

gt_junkie · 7 Jun 2007 at 21:30

You should have had copper coloured risers supplied with it.

You get a hexagonal screw driver to insert them too. Just be very careful not to thread them as the aluminium's very soft.

gt

fail at the internets · 7 Jun 2007 at 21:57

Ah kk thanks, am i meant to have enough screws to fill every hole, because i only have enough to fill about 3/4 of them.

gt_junkie · 7 Jun 2007 at 22:04

Hornchurch said:
Ah kk thanks, am i meant to have enough screws to fill every hole, because i only have enough to fill about 3/4 of them.

Your motherboard will only have holes that line up with some of the holes in the case.

The case has lots so it can accept all types of motherboards.

I'd say you'd only need around 10 but check your board to see.

Just take it slow and make sure every hole on your motherboard has a corresponding riser attatched to the case in the right place.

gt

fail at the internets · 7 Jun 2007 at 23:44

Did it thanks a lot matey.