Loop won't bleed?

KiiYzOo · 5 Feb 2012 at 16:04

I finished my loop at around 8 last night and was trying to bleed it until 3am, it didn't, so I decided to try it today, my pc has now been on since around 11:30, and it's still not fully bled, the pump sounds like there is still air in the loop, but I can only see tiny bubbles in the tubing, but when I turn off my pc after a while at the top of the loop where my tubing loops from my cpu to my res there is air there between the cpu and the res, but when I start up my pc it goes away, but when I switch it off again it comes back, anyone have any advice? (I know the first comment will probably be Cleeecooo

)

KiiYzOo · 5 Feb 2012 at 16:15

yeah, it isn't variable, and is powered on a separate molex connection

KiiYzOo · 5 Feb 2012 at 17:10

doesn't seen to want to work

KiiYzOo · 5 Feb 2012 at 17:18

If the haf x was the first loop you built, then I have been watercooling for longer than you

KiiYzOo · 5 Feb 2012 at 22:30

still not bled

KiiYzOo · 5 Feb 2012 at 22:41

no, that's the thing, it's probably in the rad, as I can't see it

KiiYzOo · 5 Feb 2012 at 23:05

Well then, it's whole case upside down time tomorrow then

should I do it with the pump running?

KiiYzOo · 6 Feb 2012 at 06:52

I put the pc on the side and filled it with one of the bottom ports, how would I get the air out then?

KiiYzOo · 6 Feb 2012 at 07:52

just had the idea of turning the loop upside down, and filling it with some more liquid through the bottom port of the res, obviously I'd take my graphics card out first

, in order to get the air out of the loop, what do you guys think?

KiiYzOo · 6 Feb 2012 at 21:02

I put the tube going into the top of the res at the bottom now, need to wait to see what happens