Lower latency or higher mhz?

Decent clock without much fuss by the look of it. That's something I don't have the patience for, ram clocking and tuning timings for efficiency.
 
Last edited:
Geeman1979 said:
Didn't you used to run some Gskill 2133 ram. If so! what did you manage to squeeze out of them?
Click to expand...

Was IMC limited on sb-e but 2450 10-12-12 was nice and easy.

To tell if you have single sided mfr's, check the trfc, if its 400+ then you have mfr, it won't lower much and its this that kills perf on them.

To put it in perspective 2400 7-10-7 spanked 2933 12-14-14 in superpi 32m by around 13 seconds.
 
Geeman1979 said:
Decent clock without much fuss by the look of it. That's something I don't have the patience for, ram clocking and tuning timings for efficiency.
Click to expand...
Tbh i only changed the primary timings and trfc to 196. 8 Pack suggested a few changes for the secondary and third timings but i never got round to trying them.
 
pgi947 said:
Was IMC limited on sb-e but 2450 10-12-12 was nice and easy.

To tell if you have single sided mfr's, check the trfc, if its 400+ then you have mfr, it won't lower much and its this that kills perf on them.

To put it in perspective 2400 7-10-7 spanked 2933 12-14-14 in superpi 32m by around 13 seconds.
Click to expand...

That's not bad at all. I run the RipjawsZ 2133MHz and struggled to get past 2400MHz last time I had a play, although didn't spend much time trying.
 
They dont need to be 2T they can go 1T for sure. I still have a kit here at OCUK use em now and again.

TRAS can be 28.
 
I say 2T as the kits I'd tried needed a hefty voltage bump to get 1T while keeping the rest of the primary timings at 10-12-12, I could do 10-12-12-28-2t @ 1.65v or 1t at 1.75-1.8v

On another note I've been offerd 2x4gb tg 2600 c10 Sammy ic for a ton, worth a punt on haswell? Need some higher capacity sticks for 24/7.
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom