• Notice regarding image hosts and attachments. See here.

Memory Suggestions

Pisto1981

Pisto1981

Pisto1981

Associate
Joined
15 Oct 2013
Posts
132
Ive had two sets of defective 16gb TeamGroup Vulcan Ram and was wondering if anyone could suggest a a good alternative?

I was looking at Avexir Venom Series 16GB (2x8GB) DDR3 PC3-17200C9 2133MHz Dual Channel Memory Kit. Would these do the job?
 
Ok, sorry for not being clear. i have 2 sets on separate occasions. with the 1st set, i added both sticks to the board and had constant BSOD until i took the broken one out. I tested the broken one in all 4 slots and had the same issue. I sent the pack back for a refund.

The 2nd set turned up, plugged them both in and all was fine for a few days, then out of the blue i had the BSOD again. Again, i tested in all slots and found the same issue.

So as ive had bad luck with both sets I was looking to getting another make

Hope this clears it up?
 
Interesting you mentioned that the heatsink could be the cause!! Would that not freak both sticks out though?

I have loaded XMP and increased the DRAM volts to 1.65v as suggested by 8 pack
 
Im going to try re-doing the heatsink on the weekend. Just a question, 8n pack said i should the check primary timings and speed is correct. Can someone walk me through this?

Failing this, i'll be getting the avexirs.
 
You must log in or register to reply here.
Back
Top Bottom