Mix Ram or not?

[musicman53]

In the past I have had mixed brands of ram(same volts and timing) in my computers but so far not with DDR2 ram.
Installed = Crucial Ballistix 2GB (2x1GB) DDR2 PC2-6400C4 800MHz Dual Channel kit running at 4-4-4-12 2T 2.2V
Have it setup to give me(via the cpu @ 13x216)2.8GHz.
Also have
GeIL 2GB (2x1GB) PC2-6400C4 800MHz Ultra Low Latency DDR2 Dual channel kit that runs at 4-4-4-12 [email protected].
Installed said GeIL kit and left everything as it was with the Crucial.
So far no problems.
Is it safe/wise to even try running that lot together without any changes?
Also Ballistix is EPP and GeIL is not so could that cause any problems?

 

[Cob]

If you've had no problems so far they you might have got away with it.

It's good to see that someone's actually tried running the Ballistix and the Geil together.

 

[musicman53]

When I first had the GeIL in the same cpmputer there were loads of lockups and crashes and that is why I stopped using GeIL and went for the Ballistix.
Have had the mixed ram in for over one hour so far without any problems.

 

[Cob]

Run MemTest86+ for 2 or 3 hours to make sure all is well.