As the title of the post states i'm modding my Old Antec 300, I was going to buy a Lian Li pc-7hx but having to pre-order gave me the time to think and work out that i could try to mod my old case.
the Antec 300 is a good case but has little to no cable management, so i am planning to jigsaw some holes,
my questions relate to where should i put the holes and where can i get suitable trim to cover the cuts.
Also should i think about turning the PSU upside so that it draws from underneath the case?
My setup is an
1 standard ATX mobo with a stock intel heatsink,
1 optical drive (top slot),
5 Drives(3 HDD (bottom 3 slots), 2 SSD),
1 Standard sized PSU,
1 PCI-E graphics card.
http://www.overclockers.co.uk/showproduct.php?prodid=CA-101-AN
the Antec 300 is a good case but has little to no cable management, so i am planning to jigsaw some holes,
my questions relate to where should i put the holes and where can i get suitable trim to cover the cuts.
Also should i think about turning the PSU upside so that it draws from underneath the case?
My setup is an
1 standard ATX mobo with a stock intel heatsink,
1 optical drive (top slot),
5 Drives(3 HDD (bottom 3 slots), 2 SSD),
1 Standard sized PSU,
1 PCI-E graphics card.
http://www.overclockers.co.uk/showproduct.php?prodid=CA-101-AN
