Monitoring a part of a network

  • Thread starter Thread starter Baz
  • Start date Start date

Baz

Baz

Baz

Soldato
Joined
9 Dec 2002
Posts
4,375
Location
Peterborough
Hope you guys can help, got a extended ethernet put in between two sites in the same town, supposed to be 100Mb :) however it keeps dropping, BT are looking at it again, but I want to fully check out the infrastructure either side. which is Fibre.

What software can I use to monitor it and kind of tell where the problem is?
 
Still not fixed it, but getting close,

Basically there is a 100Mb link between two sites, HO is straight into the Cisco stack, the remote site comes out of the NTE, into a switch, then fibre to a switch in a node 200m away to supply some PC's there, then fibre back out to a final node with two switches in, a PoE to power wifi and phones and a 48 port switch...

So far turned on STP, set all fibre ports to manual 1000Mbps with flow control, changes fly leads... Mondays job is to set up laptops at each switch and pingpath every other switch to find out where the issue is....
 
You must log in or register to reply here.
Back
Top Bottom