More PC-7 modding madness. (Need project name)

Monkey Puzzle said:
I can't link as it's a competitor, but the stuff is called 'AC Ryan MeshxPanel HEXX'.
Click to expand...

aha, I've come across some of thier stuff recently too, but only big laser cut rad grill type arrangements, not a nice mesh like this. And a high street component shop sells the speaker grill replacement mesh, but again thats not quite 'right'

I emailed your medschool address from trust
 
misterPK said:
I'm sorry, and I don't normally say this about people's mods, but the front of that just looks like a butchered mess. Why not just make the vent one big rectangle? It would look so much better if you completely removed the bottom drive bay and the section where the switch is. You could move them to the other blanking plate above or even keep them where they are now but in the expanded grill instead. Lian Li's should be about simple plain lines, not obscure shapes!

EDIT: the rest of it looks great though! :p

PK!
Click to expand...

Have to agree I'm afraid. :(

Awesome otherwise!
 
inside looks really good mate but the front u didnt cut it center due to the switch but couldn't that of been mounted in the roof behind the fan controller?
 
Bradley8988 said:
inside looks really good mate but the front u didnt cut it center due to the switch but couldn't that of been mounted in the roof behind the fan controller?
Click to expand...

Not really - there's a 20cm fan there from the previous mod I linked to in the first post, done when I was using air-cooling and had no plans to put water cooling in.
 
There's one 12" white cold cathode (on the fan controller) and a 12" UV cathode upright in the front left corner (looking at the windowed side) velcroed to the chassis behind the windowed side, and a 12" uv cathode running along the floor at the far front behind the windowed panel, but that one's gone pretty weak.
 
You must log in or register to reply here.
Back
Top Bottom