I know a couple of people would like to see this so heres a quick guide on how I fitted it. This was in a Lascala LC03 HTPC case
Normal MCE 2005 remote and receiver
To get the receiver case apart there are 2 x mini torx screws hidden under 2 rubber feet at the front of the unit. Then theres 1 more screw which holds the board in place.
I have an ideal mounting spot in my case where all I had to do to mount the board is use some sticky pads which meant the sensor itself was in exactly the right place in between the small gap in the case and the VFD board. More luck than judgement.
Normal MCE 2005 remote and receiver
To get the receiver case apart there are 2 x mini torx screws hidden under 2 rubber feet at the front of the unit. Then theres 1 more screw which holds the board in place.
I have an ideal mounting spot in my case where all I had to do to mount the board is use some sticky pads which meant the sensor itself was in exactly the right place in between the small gap in the case and the VFD board. More luck than judgement.
Last edited: