msn help

Lakeland

Lakeland

Lakeland

Soldato
Joined
1 Nov 2005
Posts
5,711
Check my clock

Abit IP35 Pro
Link to motherboard

Q6600
Link to processor

GeIL 2GB PC2-6400C4 800MHz Black Dragon
Link to ram

Would anyone mind helping me clock my new system, over msn messenger? I'm looking to get around 3.0ghz. I've overclocked before with my old opteron 148 though it would be reassuring to have someone to talk to guide me though the different steps

Thanks in advance, graeme
 
Last edited:
67872618vy0.jpg


89917359ei9.jpg


65069383yc8.jpg


16741145pu1.jpg


I had read the guide already, and have done OC in the past, i was just after someone with a bit more experience to talk to while i was doing it.

Do these look ok? Would be nice to know if there is anything i have done wrong before i run prime

I am not sure why speedfan is showing a system temp of 54oC, ive had a feel inside the case and everything is lovely and cool

Thanks
 
40649281az6.jpg


I did one prime test and core 1 and 4 failed after about 3 minutes with the error

"FATAL ERROR: Rounding was 0.5, expected less than 0.4

I bumped the volts up a few notches and ran again. The results after 5 minutes are what i have print screened. Any idea's what's up?

Thanks for the reply
 
Just ran prime again with' Round Off Checking' turned on, thread#2 failed after 4 minutes, same error as before - "FATAL ERROR: Rounding was 0.5, expected less than 0.4

RAM timings changed to " 4-4-4-15 1T " as suggested by Greebo in another post, hopefully this will sort it out

Failed again, volts raised to 1.36 as suggested below, cheers
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom