Hi
Recently (last couple of days) did my first system rebuild (see sig.). All appears to be going reasonably well... But...
On looking in Device Manager / IDE ATA/ATPI Controllers, I see that the entry for the "Primary IDE Channel" and the "Secondary IDE Channel" is repeated three times (IE. there are three entries for each). Question: is this normal? and if not, should I do something about it?
Also... should there not be an entry somewhere in Device Manager for the Sata controller? of which I believe there are two on this board!
Must admit I'm a bit confused.
Thanks in advance.
Recently (last couple of days) did my first system rebuild (see sig.). All appears to be going reasonably well... But...
On looking in Device Manager / IDE ATA/ATPI Controllers, I see that the entry for the "Primary IDE Channel" and the "Secondary IDE Channel" is repeated three times (IE. there are three entries for each). Question: is this normal? and if not, should I do something about it?
Also... should there not be an entry somewhere in Device Manager for the Sata controller? of which I believe there are two on this board!
Must admit I'm a bit confused.
Thanks in advance.