My conroe overclock :)

jongeeone · 26 Dec 2006 at 13:46

Ok after having problems when i first got this new build and not being able to overclock it more than 200mhz (memory problems, RMA geil ram). My spec is as follows hmm

Intel C2D E6300
Gigabyte DS3
Artic Cooling Freezer 7 Pro
1GB Geil PC6400
OCuK 7900GS 512mg
OCZ 520 Modstream
1 x Maxtor 160GB (Sata1)
1 x Hitachi 150GB (Sata2)
Asus MW221u - Very nice idd

Not sure what the case is but it has 1 case fan on the side drawing air in onto the GFX card, 2 on the back takeing air out from behind the AC7

I overclocked the GFX card, 3D mode its running at 575/1450 @ 40c - The core will go more but im happy with this, the RAM is locked at that, needs volt modding to increase which im not going to do.

Below is a screenshot of all 3dmark etc

Not sure if any one uses HWINFO32 benchmarks but i got ermmm

CPU Benchmark - 74924
FPU Benchmark - 46099
MMX Benchmark - 95321

jongeeone · 26 Dec 2006 at 15:26

If you look at TAT you will see that CPU is running at 100% work load ;p

idle is around 46

jongeeone · 26 Dec 2006 at 16:51

Chancers are its your ram, i had the same problem, my errors happend after 7 seconds, take out 1 module and try it and do the same with the other, if it fails on both then its ** cpu i suppose :/

What make ram is it?

jongeeone · 26 Dec 2006 at 19:14

Its your ram! I had a set from overclockers and it was faulty, had to rma it

jongeeone · 27 Dec 2006 at 18:36

your geil runs at 1000mhz? very nice idd

maybe i may get some more out of mine

D

jongeeone · 27 Dec 2006 at 22:47

Erm if you can do what you want then no, but RMA your ram any way

jongeeone · 30 Dec 2006 at 16:33

i have sorted out temps, reduced the voltage to 1.30v (from 1.45v) and temps are under/40c idle and 50/above load