my ds3p and e6300 overclock

scooby555t · 16 Apr 2007 at 16:52

3.1 Ghz
idle temps core 0 31*c - core 1 30*c at 1.216volts

andyh · 16 Apr 2007 at 17:35

Scooby
I have exactly the same overclock as you but cannot seem to get it any further without it failing orthos after a few minutes, have you tried over 430FSB?

scooby555t · 16 Apr 2007 at 17:37

yep i got mine stable at 3.5 with slight more volts what ram are u using
am using OCZ sli ram maybe its ram is letting u down if u want add me to msn [email protected] and i'll see if i can help ya out

gurusan · 16 Apr 2007 at 17:39

you're really only giving it 1.216?

Very impressive.

scooby555t · 16 Apr 2007 at 17:40

yep i took it down from stock ive been putting it down and so far its tat stable am going to keep going down until it don't boot

RaiderX · 16 Apr 2007 at 17:47

i got mine to 3.04 on stock volts and stock cooler, i used some value memory, what volts u using for 3.5?

andyh · 16 Apr 2007 at 17:48

scooby555t said:
yep i got mine stable at 3.5 with slight more volts what ram are u using
am using OCZ sli ram maybe its ram is letting u down if u want add me to msn [email protected] and i'll see if i can help ya out

I think it is the RAM (Geil PC6400C4), i used to have this chip at 3.1 at 1.3v on a P5N-e in unlinked mode before so I know there is more I can get out of it.

scooby555t · 16 Apr 2007 at 17:49

stock 1.375 haven't tryed 3.5 with anythin lower my system is running fine might try it later on tonight and see what i can get will post back when i do 3.1 on 1.216 volts though thats not bad

andyh · 16 Apr 2007 at 17:53

gurusan said:
you're really only giving it 1.216?

Very impressive.

I think the 1.216 is what speedfan reports the vcore as and not the actual voltage set in the bios. At 1.325 in BIOS speedfan is reporting 1.280 on my DS3P, no idea which is the most accurate.

scooby555t · 16 Apr 2007 at 17:55

ive got to set to that in my bios 1.216. id say this bios would be the most accurate thats also with CPUZ as well its giving me the same reading

andyh · 16 Apr 2007 at 18:04

scooby555t said:
ive got to set to that in my bios 1.216. id say this bios would be the most accurate thats also with CPUZ as well its giving me the same reading

I owe you an apology then.
I have been impressed with the complete lack of vdroop between idle and load conditions with this board, the P5N-e was terrible for it.
Out of interest what revision of this board are you using?

scooby555t · 16 Apr 2007 at 18:05

ive the rev 3.3 with the f4 bios