Associate
- Joined
- 3 Nov 2013
- Posts
- 320
- Location
- Surrey
Hi guys,
Had some spare 3mm sleeving and 4mm heat shrink laying around, so had a go at sleeving my front panel I/O cables as they are ugly garish colours at the minute. (I've also eaten so much food over Christmas I don't want to move fro my desk!)
My case is an Aerocool QS-202 (not a bad little M-ATX case, I must add!)
I realised on my first cable that I had cut the heatshrink a bit too short, there isn't as much of it on the sleeving as I would like, but apart from that the wholeoperation went smoothly.
If you guys have any tips for sleeving the rest (or CX500M cables for the future) I would be grateful
Cheers!
(below) You can see here on the right what I mean about cutting it a bit too short...
Had some spare 3mm sleeving and 4mm heat shrink laying around, so had a go at sleeving my front panel I/O cables as they are ugly garish colours at the minute. (I've also eaten so much food over Christmas I don't want to move fro my desk!)
My case is an Aerocool QS-202 (not a bad little M-ATX case, I must add!)
I realised on my first cable that I had cut the heatshrink a bit too short, there isn't as much of it on the sleeving as I would like, but apart from that the wholeoperation went smoothly.
If you guys have any tips for sleeving the rest (or CX500M cables for the future) I would be grateful
Cheers!
(below) You can see here on the right what I mean about cutting it a bit too short...