• Notice regarding image hosts and attachments. See here.

Need some quick help please

Associate
Joined
30 Nov 2007
Posts
75
Hello all, jus bought myself a new Motherboard and CPU ..

Motherboard - Abit IP35 Pro
CPU - E6850

I've just installed that uGuru, looked at the temps - all fine except the CPU one, when an application is running it creaps up onto and slightly above the 75'c limit.

When i came to puttin the heatsink on the cpu for the first time, i didn't fit it properly as it was loose. So i did it again, but i just wiped the old paste off.

Could there simply be too much paste on the CPU ? Whats the easiest way of removing it - Small bit of Vodka ? ?

Thanks in advance
 
Ye, its the stock cooler to the E6850 - Applied it myself, i had orderd the Artic Cooling paste but it didn't get deliver'd the same day - Comes tommorow so i bought some cheap and nasty from the local PC shop :( .. Think i might have applied it crappy
 
Did you clean the pre-applied stuff off the stock cooler?

Best thing to do is clean everything up with some isopropanol (isopropyl alcohol) from the chemist and apply a small quantity of decent paste when it arrives tomorrow. You only need a small amount, too much is bad for heat transfer. Have a search on applying arctic silver for some advice, literally talking a ball bearing sized amount. You want to keep temps under load below 70 ideally. Plus 1am must be a bad time for fixing a new HSF, lol :)

Lol trust me, ive had a nightmare with it not just the HSF tho :P It booted up and gave me the NTLDR message.. Went over to my mates, wired everything up and its booted up everysince Lol.

Thanks for the tips :)
 
Ye, i am considering a new cooler - as this one is a total pain ! The clips are stupid Lol I also need a bigger case :D

PayDay friday so i think ill buy two new items :D
 
*Update*

Thanks for your help on here, Took the old paste off and applied the new Artic Cooling paste - Now running at a healthy 14-17'c :D
 
Back
Top Bottom