Neither bed or hot end getting much over 50/100 degrees...

Hawk Tuah

Hawk Tuah

Hawk Tuah

Soldato
Joined
18 Oct 2002
Posts
14,209
Location
Sandwich, Kent
Hi, I've got an Anyciubic Mega X.

Been working fine for a few years. Gone through a few hot ends, and replaced the extruder.

But now I've got an issue where it seems unable to get either the hot end (a relatively new one) or the bed up much beyond 100 (end) or 50 for the bed.

Is this likely due to a failing power supply? Or is there an energy distribution board that's failing?

The software / screen all seem to work fine.
 
Nope. I've opened it up and the only thing that's directly connected to both the hot end control board and the bed control board is the PSU. So, I've ordered a replacement (fortunately it's a generic mean well industrial power supply.)

If it's not, I don't think any of the boards are available anymore - so will have to get a new FDM printer.
 
You must log in or register to reply here.
Back
Top Bottom