Turned off NAT, the router has a static external address, iv manually put in both DNS server ip's but still get no way of entering subnet, status page stills says im using...
IP Subnet Mask 255.255.255.255
In the help bit it says
nternet IP Address
If you log in to your service or your ISP did not provide you with a fixed IP address, the Router will find an IP address for you automatically when you connect. Select Get Dynamically From ISP.
If you have a fixed (or static IP) address, your ISP will have provided you with the required information. Select Use Static IP Address and type the IP Address, Subnet Mask and Gateway IP Address into the correct fields.
For example:
* IP Address: 24.218.156.183
* Subnet Mask: 255.255.255.0
* Gateway IP Address: 24.218.156.1
Domain Name Server (DNS) Address
The DNS server is used to look up site addresses based on their names.
If your ISP gave you one or two DNS addresses, select Use These DNS Servers and type the primary and secondary addresses.
Otherwise, select Get Automatically From ISP.
Note: If you get 'Address not found' errors when you go to a Web site, it is likely that your DNS servers aren't set up properly. You should contact your ISP to get DNS server addresses.
NAT (Network Address Translation)
NAT allows all LAN PCs to gain Internet access via this Router, by sharing this Router's WAN IP address. In most situations, NAT is essential for Internet access via this Router. You should only disable NAT if you are sure you do not require it. When NAT is disabled, only standard routing is performed by this Router.
Dont see any options for this though?
