New build help

runing.man · 8 Nov 2007 at 18:19

ok so i have the new rig up and running but need a little help as i have the gigabyte P35C DS3R and the GeIL 2GB (2x1GB) PC2-6400C4 800MHz Ultra Low Latency DDR2 Dual Channel Kit and i have read that you have to adjust the memory voltage on the mother board to match the voltage of the memory .

so on the memory there is a sticker that says the voltage of the memory is 2.1v
so how do i do this from here it says i can go up 0.1,0.2 etc but in the bios it says the memory voltage is on normal and pc is running good so far but i aint tried a game so do i need to change the voltage or not ? and on the motherboard it says its Rev 2

Thanks for your help

runing.man · 8 Nov 2007 at 18:39

ok i will wait to see if some one confirms this then and thanks for help

runing.man · 8 Nov 2007 at 18:40

ok thanks what do i need to change the timings for is this a must do ? sorry if im unsure its my first build

runing.man · 8 Nov 2007 at 18:49

ok so the first timings if im correct are reading 333 so i change that to the 444 ?

runing.man · 8 Nov 2007 at 18:54

ah ok thanks for your help

runing.man · 8 Nov 2007 at 19:08

so do i change it like these where i have marked green ?

but instead of the 0.4v i go to 0.3v

runing.man · 8 Nov 2007 at 19:16

ok i will give that a go in a min thanks again

runing.man · 8 Nov 2007 at 19:37

ok i have done all that can you just check it to make sure its all right here is a picture

Thanks

runing.man · 8 Nov 2007 at 19:51

where would that be then as i though it was the one above where it says 800Mhz

runing.man · 8 Nov 2007 at 20:01

ok i will check that right now

runing.man · 8 Nov 2007 at 20:07

yeah its at 800

so its all good then ?

runing.man · 8 Nov 2007 at 20:12

ok then big thanks to you i would have been lost otherwise thanks allot