New Build Journey
- Thread starter stotts
- Start date
Is a bit hard to see what channels there are in that distro plate. I was very confused at first but in the end I worked out the pump out and realised the fluid would then just flow from there and around the loop until it returned to the resevoir section. You appear to have a 2 pump distro plate so will be differenet to most other peoples. My advice is to just sit down with a cuppa and think. You will see the logic in the end. One point to remember is that the EK cpu block has an in and out port so make sure you check which is which before bending tubes.
Looking forwards to seeing the finished article , I am sure it will look glorious.
Looking forwards to seeing the finished article , I am sure it will look glorious.
Associate
- Joined
- 2 Jun 2020
- Posts
- 115
I can’t figure out the dual reservoir either. Pictures made it seem like the big section is the out and the smaller one is the return, but the bottom loop seems to reverse that. I know that the loop will equalise temperature, it just seems weird to have say gpu output going straight back to the res
Associate
- Joined
- 2 Jun 2020
- Posts
- 115
Looking at the pictures on his site I’d guess that the lower left is the out to the cpu, the one above is the return. The two right channels are for the rad.
Similar layout on the bottom loop.
Drop Mario an email, he just clarified mine for me.