New case need help please

Bungus · 27 Nov 2010 at 20:44

Hi I have got my self a new case,
I am swapping over the motherboard on to it but i have hit a snag and hope someone can help me.
The wiring has different connection to the one i am taken out.
The power button from the old one was a nine pin, where as my new case has individual two pins.

This is the new wiring

https://flic.kr/p/8WBN21

This is the old wiring

https://flic.kr/p/8WBNyf

Dont want to blow it up. LOL

The Motherboard is a IPMTB-TK (Truckee)

The case is Tsunami Aluminum Case

Any help appreciated

C64 · 27 Nov 2010 at 22:19

Look in the board manual should say what goes where.

You aren't going to blow anything up all that will happen is it wont work until placed correctly.

Tealc · 27 Nov 2010 at 22:28

Funny though as the 9 pin (10 pin connector with one blanked off) is normally for front panel USB.

I would have thought all cases would be the same, or at least similar for it to confirm to the atx standard.

Maybe thus motherboard is of a proprietary design and not atx at all, and therefore tricky to install in a new case.

Bungus · 27 Nov 2010 at 22:31

That's another problem I don't have a manual,

Bungus · 28 Nov 2010 at 21:12

Sussed it, i put the power and the reset to the back four,
And the other well, one was a three pin and the other was a two pin.
Five at the front, four at the back simple when you have no alchol in you.

The i had an ERROR: SYSTEM FAN FAILED.
After 10 mins of wondering what that was, I discovered a small yellow wire not plugged in, (fan)

Now works a treat.
Although the fans are so noisy i need to buy silent ones.