• Notice regarding image hosts and attachments. See here.

new PC, no post

Associate
Joined
22 Sep 2008
Posts
3
Hi, just got the parts for a new PC

CPU: Intel Core 2 Quad Q9550
MOBO: Asus P5Q-E
RAM: 4GB (2x2GB) Corsair Dominator DDR2 PC2-8500
GPU: 512MB Gigabyte HD4870
SND: Creative SoundBlaster X-FI Xtreme Gamer
PSU: Corsair HX620

Only problem, it doesn't post, the monitor doesn't seem to get any signal.

When i press power the fans spin up then a few seconds later they spin down, and a second after that they spin back up.
 
Just had the same problem with my new build, take the GFX card out and make sure theres no dust or anything in your PCI slot, mine had some grass in it :(
 
Have you connected all power cables inclcuding the 4 or 8 Pin for the cpu power and gpu power supply.
Reset the CMOS and onlu use 1 stick of RAM.
 
I'm building a very similar system and have the same problem. I have a brand new Asus P5Q-E, Q9550, 2 x 2GB Geil RAM and a decent PSU. There's a new Radeon HD 3450 in the PCI-E slot (I'm not a gamer). This has no additional power connector.

It powers on but does not POST. There's no beep from the BIOS. I've tried resetting the CMOS and using a single stick of RAM, but no joy. I have no cards installed and have not yet attached any drives.

Any ideas what else I could try please? I'm baffled by this one...
 
Im having exactly same problem with my new build have a new Asus P5Q Deluxe and Q6600 as well as an 8800GT, I dont hear any beep codes as I dont know which cable to put in the mboard from the Antec 1200 :rolleyes:

Have tried my previous E6400 cpu and still same thing so its not the CPU. (touched them when booted warm to touch)

I have tried a reset of cmos but havnt taken the battery out? Is it best to do both?
 
You shouldn't need to touch the battery.

I think with your board you just move the multiplier, boot the PC. Open bios and press f5 (Reset defaults). Save and exit (f10). Turn the PC off after reboot and move the cmos multiplier back to it's original state.

Check your manual first though :P
 
Back
Top Bottom