New W/C setup

[ste2005]

Hi Guys ive bought this set up:-

CPU Block- http://www.overclockers.co.uk/showproduct.php?prodid=WC-044-XS&groupid=701&catid=193&subcat=1034

Pump/ res - http://www.overclockers.co.uk/showproduct.php?prodid=WC-027-XS&groupid=701&catid=193&subcat=1042

Rad- Alphacool NexXxoS Xtreme III - Rev. 2 (this was free.)
Im using 3/8 tubing and barbs. Im just preping the rad.

My questtion is how do I go about bleeding the system of air when I've set it up?

Thanks

 

[ste2005]

Yeah I might stick a GPU block in their, got most bits cheap so... Your advise is just to take my time setting up. My Rad will be at the top of my case (haf 932) and the pump at the bottom.

 

[ste2005]

yes take ya time,and you wont get any problems,be carefull when filling up as the res will empty pretty damn quick,im sure your aware of how to jump start the psu so you only have the pump running ect,like everyone said your pump should do the work for you,also if you seem to get air stuck in rad tilt the case towards you ect.good luck and enjoy i did,and want to build more if i had the chance.

if you want ideas about where to put your res/pump check me build below.

Cool build. I want to put my res and rad in simalr place to yours. Ive got a spare PSU that im going to be using and im think in know how to jump start my psu (paper clip over green and black wire)

 

[ste2005]

Thanks for the tips guys. Ive just finished preping the rad, so i guess im ready to leak test, wish me luck

 

[ste2005]

ahh of course, wont see much ive gone 4 black tubing, cant stand uv.