No signal when starting rebuilt computer

sorcerer · 23 Mar 2007 at 20:51

Hi Everyone,

I just bought a new case for one of my older PCs, it's an Iwill K266plus R mobo, and after I rebuilt it I can't get a picture up on the screen. I hear no beeping at all from the mobo, even though their is a light on, and all the fans, hard disk and GPU have power.

So far I have tried the following.

Replaced the PSU
different memory in different slots
Replaced Graphics card
Built PC out of case with basic setup with no luck, on antistatic bag.
Reseating CPU

And not of it makes any difference, still no beeping or picture. I can't replace the CPU since I don't have a spare that would fit, and probably no chance of finding one either. So I'm suspect the motherboard has had it. Can anybody else think of anything else I can try?

mk17 · 23 Mar 2007 at 22:17

sounds like mobo, or cpu, sorry

quad · 23 Mar 2007 at 22:25

I know it sounds silly but you've put the monitor lead into the graphics card haven't you and not the on-board graphics? :confused:

sorcerer · 23 Mar 2007 at 23:59

quad said:
I know it sounds silly but you've put the monitor lead into the graphics card haven't you and not the on-board graphics?

Yes indeed, their is no on board graphics on the mobo.

nc11 · 24 Mar 2007 at 08:53

If your new case has a 12V ATX molex (4-pin) on top of the standard one, you might need to connect that one as well for the mobo to have enough power. I've had that with a new box recently.

sorcerer · 24 Mar 2007 at 12:51

nc11 said:
If your new case has a 12V ATX molex (4-pin) on top of the standard one, you might need to connect that one as well for the mobo to have enough power. I've had that with a new box recently.

I'm afraid the mobo, has no 4 pin connector, it was manufactured before the 4pin cable was standard.