Not getting full GPU utilisation

[Dumphole]

Hi all,

So I changed to a 240hz monitor today from a 165hz item. I have always capped my frame rate to keep just inside my monitors upper g-sync range so today I adjusted that to reflect my new monitors increased refresh rate however, try as I might I cannot get my GPU to fully utilise and give me the extra frames I want.

Setup:
Gpu - 2080ti, water cooler and oc'd
Cpu - 8700k at 5mhz and watercooled
Ram - 32gb at 3200mhz
Monitor - XV273X
PSU - ROG Thor 850w

To be clear, I'm getting aroun 50-75% cpu and gpu usage whilst playing R6, frame rate is uncapped and I get between 190 and 270 ish fps. I never reach full gpu/cpu usage, I never reach power limits, I'm no where near overheating, nothing else significant is running.

I've tried changing all w10/NV settings to max power but this achieved nothing.

Any ideas?

 

[Dumphole]

My ram as it is will bottleneck my gpu to the % it is?

 

[Dumphole]

In the R6 cut scenes it will max the gpu out oddly.

 

[Dumphole]

No I've stated above that cpu usage is very low, around 50-75 percent load. Its not bottlenecking the card.

 

[Dumphole]

I want full gpu utilisation so I can set my fps at a solid 240 to match my monitors up gsync range.

 

[Dumphole]

I've usage on all cores and I'm never getting more than 75% and all cores are being utilised as much as each other..

I checked render scaling, its set to 1080p.

My cpu is delidded and cooled by an open loop. Its definitely not getting hot.

I think its a game thing. Unless the ti has some form of internal data transfer bottleneck hence being not good at 1080p.

 

[Dumphole]

I've taken the ram to 3600 but no change.

 

[Dumphole]

 

[Dumphole]

The bit at 9.12 was R6 and the fps was almost identical. Annoying that a 2060 was doing so well yet my much more powerful card wasn't that much better.

 

[Dumphole]

I've tried everything uncapped and still see the same thing.