• Notice regarding image hosts and attachments. See here.

OC'ing a E2180

Associate
Joined
14 Dec 2009
Posts
50
Hi,

I'm running Abit IP35-E, DualCore E2180@2ghz, Arctic Cooling Freezer 7 Pro CPU Cooler and attempting my first OC in prep of a Q6600 arriving in the post soon.

I up'd the CPU to 240x10 and ran prime95 without issues - max temps 53. when I tried to go for 266x10 the system wouldnt boot at all. I thought I'd broken it completely - but after leaving it off for 5 mins it allowed me to go into BIOS and revert to 240x10.

Is this a voltage issue? should I consider:

1. lowering the multiplier and upping CPU
2. upping voltage?

I'm nervous about fiddling with the voltage as I know that can fry the chip. Is it ok as long as the temp remains below low 60's?

If I do push it further and it gets stuck before BIOS, is there anything I can do besides waiting for it to cool completely and just hope it'll boot up so I can revert the settings??

thanks guys!
 
voltage at present is low - 1.2 or something similiar - will check when home. I've read that my chip can get to 1.4 fine - just nervous about doing it!

- As long as I up it incrementally and monitor the temps I should be fine though right??

I've done a fair amount of reading already - was told that if i upped it too much it would just fail to boot and I could reset from the BIOS. there was nothing about failing to get to even get to BIOS

I think it's because my Pc 'double boots', i.e. fires up for 3-5 secs, turns off, then boots up properly. it seemed to get stuck on this first boot. I think this is a problem with my Mobo - was advised (on here) that it wasnt really an issue unless it bothered me (which it doesn't)
 
Back
Top Bottom