OCZ zx 850 watt

h20extremepcs · 7 Nov 2021 at 19:16

I am trying to put a new connection on the psu side I went with a pin out on another form but there’s more cables than holes on the connector can anyone please help me out with a pin out

h20extremepcs · 7 Nov 2021 at 19:18

h20extremepcs · 8 Nov 2021 at 15:32

I did test it before I removed the header and yes it was a very stupid thing to do without writing down a wiring diagram. If two wires go into one hole they are joined together with one pin so that’s not the case. I have found a pinout picture for the psu but as I say there are too many wires for the holes. I will take another look and try again. Thanks for your reply regards Mark

h20extremepcs · 8 Nov 2021 at 15:38

https://forums.extremeoverclocking.com/showthread.php?t=356582

Here is the pinout

h20extremepcs · 9 Nov 2021 at 15:34

No I still have the original pins on the wires. I was going to sleeve the cables but instead upgraded to an ASUS rog strix 1000w I am going to get a custom set of cables sleeved with paracord as sleeving is a tedious process. I don’t mind doing it I just don’t have the time at the moment

h20extremepcs · 9 Nov 2021 at 15:47

I am very capable of sleeving, this is some of my work for an ATX extension. I only have 3 wires left to make and sleeve. I just have not bothered as I don’t intend to use it anymore. I will finish it then test it with my psu tester and sell it on eBay for £15 or so. What do you think?

[URL]https://i.imgur.com/UWObq32.jpg[/URL]
https://imgur.com/a/gixPBoS
https://i.imgur.com/aCWeMti.jpg