opteron 150 on a shuttle

[NqR]

Hello.Since i am a bit of a lazy newbe(yes NOOB) on overclocking i want to
be proposed some setup for my pc.
I ve got an opteron 150(2.4ghz) the venus core(90nm).I was told that this is the E4 Revision.
I am on a shuttle sn25p with ocz platinum cas2 2gb ram.

I would like you to suggest me a setup that i will not face any major increase in heat cause i want to run my fans at ultra low if it is possible.
Thank you for your time

 

[NqR]

as i said i am a bit noob
Can you please specify me what values/settings shall i put on the bios?
If i change the fsb wouldnt this affect my ram?

 

[NqR]

Thank you very much
I will try them and post back

 

[NqR]

I need to set the following settings
CPU Frequency(default is 200).shall i set it to 250?
HT Freq(def auto) set it to 4x?
ht width(16down , 16up)

I ve got the dram configuration(i have it at cas2 ddr 3200 settings)
Also what to you mean by 5:4 divider?
edit:i ve just read carefully about the divider.250htt so i should set the ram freq 200?That the stock ram freq right?

 

[NqR]

SN25P has a 1000 hyperbus [or whatever its called]

4x & 250 is spot on

default is 5x and 200

If i set the cpu freq to 250 and ht freq to 4x it wont boot.
It will show me a message in bios that the safe settings are on and that i should readjust cpu freq.

 

[NqR]

the bios wont let me boot with 250htt(known as cpu frequency in my bios).
Even if i lower the ram at 166 or at auto settings.
Btw what's ht width?it is set at 16up and 16 down.
I ve got it flashed to the latetest bios btw.

I tried some settings by myself though i didnt knew what i was doing
I tried 250htt x3 auto ddr settings -->bios massage again
225hht didnt get the bios message but the pc wont boot in windows,restarts.

Any help please?

edit:dont know if it is important right now but the current bios only goes up to 250cpu freq.From what i read on forums this may be a bios version issue since the majority of sn25p go up to 300htt

 

[NqR]

at stock in bios the cpu temp is 40C and system temp is 47C

Speedfan temps are around CPU 49 idle and 50-51 under 100% cpu usage

 

[NqR]

any further help?
I will flash the bios to the y version.
Something i did understood is what the ht freq does(the 4x,5x etc).
I really appriciate your time and effort

 

[NqR]

You guys are forgetting that 12x250 = 3Ghz. Which I seriously doubt is possible on stock volts even with an Opty 150. Try lower the CPU multiplier to 11x, HT 4x, Ram Divider 5/6 - this will allow a slight oc on the ram which it should be capable of.

noob alert here.how do i lower the cpu multiplier?
The ram devider is a setting i change?or just a reference so that if the htt is set to 250 lets say i set my ram freq to 208?
Also does ht width affect anything?