Overclock with Dead space 3

[kevbiss1]

Just played through Far cry 3 (eventually) and then dashed through Tombraider,both with my 7850 overlocked to 1100mhz,(both games no problems at all)
Just started Dead space 3,same settings ,BSOD several times after about 30mins into the game.
swept all AMD drivers and reinstalled latest drivers,still the same
Reset o/clock to stock settings,no further problems,played for 3 hours today
Anyone else had problems withis crappy consul port?

 

[kevbiss1]

Latest,13.4, I think,as I said,if you get problems,just run at stock,all settings set too pretty much maxed out,with v sync set to off,otherwise you only get 30fps.

 

[kevbiss1]

will give that a go when I get chance,but as I said as its ok running at stock,i might just blast through as it is,sometimes you can end up faffing around for hours and get no where!

 

[kevbiss1]

Maybe,but I played Farcry 3 with no problems and that was a far more hardware demanding game,my fps were up and down in that game

 

[kevbiss1]

ive never come across this before,i know all games run differently,and crisis was tough on my hardware(gtx 470 and an amd 720), but ive never experienced bsod due to graphics card settings

 

[kevbiss1]

On the plus side the game is so undemanding you don't need to overclock the gpu.

that's true,and its only DX9