Overclocked Q8200 on Lanparty reseting computer

[bushmins]

Lanparty Q8200 overclock causing reset only after complete power off
Hello
My motherboard : DFI Lanparty UT P45-T2RS

I have overclocked my Q8200 from 2.33 to 2.8. When i start my computer from a complete power down i.e. turned off at the mains the board hangs at the code '26' then auto restarts and boots up fine. If i just turn the computer off and dont cut it off from the mains it boots fine.

The code '26', according the the manual, is because

'Initilized wrong BIOS process. (Clock-gen circuit/super IO circuit).

If i remove the clock then it doesnt have this freeze/reset problem. I have no idea what to do to sort this problem, does anyone have a clue as to what to do?

Thanks.

 

[Firegod]

If I shutdown, everything is fine. But, when it's been turned off at the mains, say due to a power cut or by having the mains switch turned off, it will boot then do an auto restart then boot again, with the overclock.

I'm pretty sure that's normal.

 

[bushmins]

If I shutdown, everything is fine. But, when it's been turned off at the mains, say due to a power cut or by having the mains switch turned off, it will boot then do an auto restart then boot again, with the overclock.

I'm pretty sure that's normal.

Not sure what yopu mean there? Are you saying you have the same problem with your overclock?

Maybe you didnt understand me fully.

If i shut my computer down (normally via windows) then unplug it from the mains i get the hang/reset at code '26' the next time i power up the computer. This problem is not seen if i shut down the computer (via windows) and start it again without unpluging it from the mains (after doing a normal shut down via windows).

Theres no catastrophic shut down involved in this - no power cut or loss of power.