its been a while since ive had a decent enough system to bother with overclocking it, so ive built the bellow pc and started to overclock it. just wondered how far things can be pushed now?
Processer is a E6300 @ 1.86Ghz which ive managed to get running a 3.09Ghz (on stock volts) stable in Super Pi and Prime 95 does this seem reasonable???? or can i push futher? being cooled with a large asaka heatset and fan and under load for 20 minutes or so seemed to be pretty stable at 67*c is this acceptable?
ive had less luck with my graphics card which is a powercolor 4850 1gb i managed to get the processer up to 670mhz and the ram up to 1000mhz ive seen people have achieved a lot better than this but i find if i go any higher i tend to get lots of artifacts in the image, could i be doing something wrong here? is it posible to increase the voltage etc? not something ive ever tried before so complete noob here.
Processer is a E6300 @ 1.86Ghz which ive managed to get running a 3.09Ghz (on stock volts) stable in Super Pi and Prime 95 does this seem reasonable???? or can i push futher? being cooled with a large asaka heatset and fan and under load for 20 minutes or so seemed to be pretty stable at 67*c is this acceptable?
ive had less luck with my graphics card which is a powercolor 4850 1gb i managed to get the processer up to 670mhz and the ram up to 1000mhz ive seen people have achieved a lot better than this but i find if i go any higher i tend to get lots of artifacts in the image, could i be doing something wrong here? is it posible to increase the voltage etc? not something ive ever tried before so complete noob here.
