• Notice regarding image hosts and attachments. See here.

Overclocking Advice Needed

Associate
Joined
23 Aug 2010
Posts
165
Hi all,

I have been having a go at overclocking for the first time without the use of Gigabytes Easytune6. I have a Gigabyte GA-Z68MA-D2H, a Intel 2500K, 8gb XMS3 ram and an articfreezer pro rev2 running in an Antec P180 case with an XFX 850 modular PSU.

With Easytune6 running prime 95 for 2 hours my max load temps were 79C, 82C, 83C & 80C & at idle in the low 30s.

I then proceeded to up the multiplier in the bios to 46 with everthing else on Auto& I ran Prime 95 for 2 hours again. The max load temps were now 83C, 86C, 88C & 84C although in the bios (touch bios) it says core temp 72C.

Now these temps look quite high to me, but it seems pretty stable (temps got with Coretemp). I was wondering if I ought to lower the overclock as these seem too high?, reseat the cooler or get another cooler, I have been looking at the Thermalright Silver Arrow (not sure if it will fit though) but if these temps are acceptable I will be happy with this overclock. Any tips welcome

thanks

Will
 
Last edited:
Hi,

I have uninstalled ET6 and will try reseating the cooler tomorrow, when I seated it i spread it on pretty thin & then skimmed it with my credit card like someone at work advised, I will try the rice grain/pea sized method as I have seen advised on here.

Thanks for the replies

Will
 
After reseating it with a pea sized blob of thermal compound the temps were
84C, 89C, 91C & 86C, this was after 3 mins so I think I need to do it again. So I did it again & after 5 mins the temps were hitting the low 90'sC. This seems far too high. Another cooler could be the way to go?
 
Last edited:
I will go to around the £50 mark, the quieter the better, preferably not water, having water in my case just seems wrong, but if its the best & cheapest option I would consider it. Its an Antec P180 case & I was looking at the Silver arrow but unsure if it will fit.
 
Hi,
I have dropped the Vcore by 0.100V and after running prime95 for 1 hour @4.5ghz the volts are 1.25V and the highest core temps are now 76C,80C, 82C, 78C which is an improvement. I might try and drop it a bit more later. It seems stable so are these temps & volts OK or would you say drop it a bit more?
 
Back
Top Bottom