Overclocking / Motherboard Problem

stumpy6

stumpy6

stumpy6

Associate
Joined
13 Jan 2006
Posts
113
Hello. I have a problem that i hope somebody maybe able to help me with.
Up till this afternoon i was able to overclock my E6550 on a P35C-DS3R to 3.2mhz with no problem. I had a problem in that it would not post after a reboot. So i reset the bios. Now it will not overclock at all.
I can sent the fsb to 458*7 =3.2mhz in bios, when i reboot it shows on the post screen it is only at the default (333*7=2.33mhz), going back into bios it still shows that the fsb is @458.
Ive tried cpuz and also EVEREST Ultimate and both say the same thing the cpu is running at 2.33mhz.
I thought updating the bios might sort out the problem so i did, from the F10 to F11 but it hasnt.
Also if i used the load optimal settings in the bios it sets the fsb to 100*7 = 700Mhz which is below the default.
So any advice that anybody can give me would be gratefully excepted in getting this problem sorted.
Here are a couple of photo to show what im on about.
http://i120.photobucket.com/albums/o183/stumpy6_317/DSC00064.jpg
http://i120.photobucket.com/albums/o183/stumpy6_317/DSC00065.jpg
 
sorry for the delay in me answering, been at work since 5 this morning. I had it running for about 3 months @3.2Ghz with not a problem. I saved the overclock into one of the memory banks . I had a problem in that it hung before post after a reboot (which i hadnt done for a week or so). after a couple of time trying to get it to reboot and it wouldnt, so i cleared cmos, it then rebooted. I now can set a overclock in bios, but when i reboot all that is showing on the post screen is it still at default speed, even cpuz and EVEREST Ultimate show the speed to be 2.33Ghz. Ive tried to use the one i saved in the memory bank but it makes no differance.
 
Yes. here are a couple of pictures i have just taken.
DSC00066.jpg

DSC00068.jpg

DSC00069.jpg

3.jpg


Now on this board it has dual bios. could it be that it has gone into say bios 2 (if there is one) and this one cant be overclocked for whatever reason?
 
Ive done that (loading optimized default) a couple of times. and all i get is 100*7=700mhz. which is lower than the default which should be 333*7. Looks like i may have to get a new board on payday. roll on thursday lol.
 
yeah everything was the same as before. the memory ran @916 on the board before this one (P965-DS3) and also on this one no problem. i have even had a set of crucial ballistix PC5300(667mhz) running @916 on this board and also the DS3. i only changed the ram about 3 weeks ago. I sold the p965-ds3 at the weekend to my brother (wish i hadnt now). Ive put in the ballistix to see if it was the ram that was stopping me but that made no differance. i am using now OCZ Platinum XTC PC6400 (800)
 
You must log in or register to reply here.
Back
Top Bottom