P182 cd drive rails

Screw the rails onto the side with the metal clips about level with the front of the drive. They bend slightly outwards away from the drive.

They should then slide in nicely.
 
oh the metal clips go to the front where you put the cd in? I had the metal bits towards the back......... do the metal bits bend outwards?
 
Did none of your cases come with a manual then?! ;)

Actually, to be fair, the cd rail thing got me at first when I did the exact same thing as the OP!

The rail thing is quite handy once you've screwed them on the first time, and it makes for easier re-configs later on if like me you're always fiddling with your watercooling loop!
 
haha - i did read the manual - it just confused me a little - a picture is worth a thousand words :P Loving this case - has been a bit tricky to put together, but its worth it....... The wires at the back is good, but had to squash em in very hard when sticking the case panel back on :P
 
yea they are tricky cases to work with, but if u need any more parts, just email antec and they usually just send the parts out to you at no fee
 
You must log in or register to reply here.
Back
Top Bottom