What's the best place to mount a PA120.2 in the TJ07? I've seen 240mm radiators in the bottom of people's TJ07's, but there's no 120mm fan mounts in there as far as I can see. How much drilling would it take to get the radiator nice and snug inside? I've seen 360mm+ radiator stands designed for the TJ07 that fit into the bottom of the case for easy mounting but nothing in relation to a PA120.2. What have people using a similar setup to me done?
PA120.2 in TJ07
- Thread starter iKettles
- Start date
Associate
- Joined
- 21 Jan 2004
- Posts
- 1,608
- Location
- South London, between hea
my 120.3 just sits on its side, bought some rubber feet for it and its fine
Not as bad as you might think it is.
My temps on the processors(i7 @3.8) and GFX are around 28 idle 44 max load.
This is a single loop system double pump, double rad setup linked to the 480 cooling my processor, GFX, Mosfet, NB/sb!
Fans on the 480 are pushing cold air over the rad, fans on the swifty are pulling the warm air from the system.
Loop - EK spinner bay reservoir, Pump 1 - 480 - 280 - Pump 2 - GFX - SB - Proc - Mosfet - Res
Water is passing two rads before components upstairs.
shot from the rear need to take some new snaps seems how its all setup now..
My temps on the processors(i7 @3.8) and GFX are around 28 idle 44 max load.
This is a single loop system double pump, double rad setup linked to the 480 cooling my processor, GFX, Mosfet, NB/sb!
Fans on the 480 are pushing cold air over the rad, fans on the swifty are pulling the warm air from the system.
Loop - EK spinner bay reservoir, Pump 1 - 480 - 280 - Pump 2 - GFX - SB - Proc - Mosfet - Res
Water is passing two rads before components upstairs.
shot from the rear need to take some new snaps seems how its all setup now..
Last edited:
Associate
- Joined
- 21 Jan 2004
- Posts
- 1,608
- Location
- South London, between hea
do you have right angled barbs on your rad fittings? imagine its a tight squeeze fitting two rads in the bottom without them?